FLA-1 Helix V 3605 PN16

Pressure-boosting system to be connected indirectly as fully automatic single pump compact unit for fire extinguishing applications.

Consisting of:

Non-self priming, high-pressure multistage centrifugal pump in vertical design, impellers, guide vanes, stage housing are made of stainless steel. The entire, high-efficiency Helix series is equipped with a user-friendly mechanical seal (X-Seal) in cartridge design and standard gasket for easy maintenance. The flexible lantern design permits direct access to the mechanical seal. IE3 standard motors, 3-phase, 2-pole.

Diaphragm pressure vessel (capacity 8 l), integrated non-return valve, shut-off valves on suction and discharge side (sealed in opened state), manometer, pressure switch for automatic system control.

Comes as standard with pump protection by means of minimum volume acceptance via bypass without auxiliary energy.

FLA switchgear for fire-extinguishing systems in accordance with DIN 14462. Scope of functions and suitability in accordance with DIN 14462 have been proven by TÜV test report.

Switchgear integrated in steel sheeting housing.

With integrated motor protection only for signalling faults. The motor protection is activated in the test run.

Switch for manual-automatic mode. Control of the pump by pressure switch in automatic mode; optionally expandable to up to eight sensors (in series connection), for example external on/off limit switch etc. (more than eight sensors on request). All sensor signals which could lead to the pump being started are monitored for wire breakage and short circuits.

System with programmable time switch for regular test run.

Dry-running protection relay, for example, for connection of low water float switch from the Wilo FLA break tanks, electrodes, pressure switches etc.; low water status only for signalling of faults. Low water is activated in test run.

With signal lamps for operational readiness (green), pump ON (green), fault (red), pump request (white) as well as potential-free contacts for operational readiness and collective fault (possible as common signal) and pump ON.

Suitable for use in industrial and residential environments in accordance with the basic requirements of guideline 2004/108/EC (EMC Directive).

The system has been mounted on the base frame with wires and pipes are ready for connection.

The customer must take suitable measures to ensure that the flow pressure of 8 bar and the static pressure of 12 bar are not exceeded at any fire hose reel.